AOpen DX34 Manuel d'utilisateur télécharger pdf (Page 3)

This motherboard supports DUAL processors for Intel PentiumII / Pentium!!!, and

Celeron CPU (applied to PPGA package only, must lower than 300MHz). Please refer

to the following table for detail. It is not recommended to change the default setting,

unless the system fails to boot and you’re trying to troubleshoot.

Processor

CPU Package

Configuration

Single Processor

PentiumII

Pentium!!!

Celeron

All Default

PentiumII

Pentium!!!

All Default

Celeron

PPGA Set the SW3 to OFF

Dual Processor

Celeron

FC-PGA Not Supported

When you are using the Intel

engineer sample CPU with DX34/DX34Plus, the SW1

allows you select the CPU ratio from 2x to 9.5x

. You can adjust the SW1 to get the correct

CPU working ratio and frequency.

5. SW1 Setting CPU FSB Frequency & Ratio

4. SW3 Select CPU Type

3. Installing Thermal Sensor

GND

Sensor

The Thermal Sensor Connector (

CN12 & CN1) provides you to use the thermal sensor

to detect the CPU temperature of the components on the motherboard.

OFF

SW3

Warning: We strongly recommend you do

not overclocking your CPU and system for

get more system reliability.

SW1

OFF

Bit1

Bit2 Bit3 Bit4 Ratio

Frequency

(FSB100)

Frequency

(FSB133)

On On On On X2 200 266

On Off On On X2.5 250 333

On On Off On X3 300 400

On Off Off On X3.5 350 466

On On On Off X4 400 533

On Off On Off X4.5 450 600

On On Off Off X5 500 667

On Off Off Off X5.5 550 733

Off On On On X6 600 800

Off Off On On X6.5 650 866

Off On Off On X7 700 933

Off Off Off On X7.5 750 1000

Off On On Off X8 800 1066

Off Off On Off X8.5 850 1133

Off On Off Off X9 900 1200

Off Off Off Off X9.5 950 1266

(Default)

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

AOpen DX34 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères AOpen DX34